Used as rs-232c printer, How to set parameters, In standby mode, press function, 0,9 and enter – Brother FAX-2000P User Manual
Page 121: Press 2, 4 and enter
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Used as RS-232C Printer
The FAX-2000P can be used as a printer for an asynchronous ASCII
computer through an optional RS-232C interface.
To use the FAX-2000P as a printer, your computer must support Xon/Xoff,
either through its operating system or through applications software.
Before setting up the FAX-2000P as a printer, make sure that the
computer supports Xon/Xoff.
How to Set Parameters
In standby mode, press FUNCTION, 0,9 and ENTER.
9 . U s e r S e t t i n g s
0 1 - 1 2 E n t e r / S e l e c t
l . S e t P h o n e T y p e
0 1 - 2 5 E n t e r / S e l e c t
Press 2, 4 and ENTER.
2 4 . R S - 2 3 2 C P a r a m e t e r
0 1 - 2 5 E n t e r / S e l e c t
B a u d R a t e :
3 0 0 b p s
E n t e r / S e l e c t
Select baud rate. Press SELECT several times to choose
300,600,1200, 2400,4800 or 9600 bps. Then, press
ENTER.
D a t a L e n g t h ; 7 B i t
E n t e r / S e l e c t
3)
Select data length, press SELECT to choose 7 or 8 bits,
(normally, 7 bits). Then, press ENTER.
P a r i t y :
N O N E
E n t e r / S e l e c t
Select parity bit. Press SELECT to choose NONE, ODD or
EVEN. Then press ENTER.
S t o p B i t :
1 B i t
E n t e r / S e l e c t
(h
Select stop bit length. Press SELECT to choose 1 or 2
y bits. Then, press ENTER.
109