Setting the communication confirmation report, In standby mode, press function, 0,9 and enter, Press 0,8 and enter – Brother FAX-2000P User Manual
Page 74
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Sending Documents
Setting the Communication Confirmation Report
The communication confirmation report is printed automatically after
transmission is oompletad and consists of two types of reports; Transmit
confirmation report and receive confirmation report.
The transmit confirmation report shows the communication result based
on the data included in the transmitting side (i.e. your machine).
The receive confirmation report is sent back from the receiving side after
the transmission of the fax message is completed.
Consequently, the reliability of the information on the receive
comrhunication result is higher than that of the transmission confirmation
report.
However, the receive confirmation report can be printed out only during
communication with another FAX-2000P.
Select a type of confirmation report and set the auto-output function
ON/OFF as shown below.
In standby mode, press FUNCTION, 0,9 and ENTER.
9.User Settings
01-12 Enter/Select
l.Set Phone Type
Gl-25 Enter/Select
2
Press 0,8 and ENTER.
8.Set Comm, Report
01 - 25 Enter/Select
RCR
Enter/Select
Select RCR (receive confirmation report) or TCR
(transmit confirmation report) by using the SELECT key,
then press ENTER.
Automatic Print;On
Enter/Select
62