American Diagnostic Corporation (ADC) ADview Modular Diagnostic Station - Manual (Page 60)

50
This equipment has been tested and found to comply with the limits for medical devices to IEC60601-1-2:
2001. These limits are designed to provide reasonable protection against harmful interference in a typical
medical installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to other devices in
the vicinity. This equipment should not be used adjacent to or stacked with other equipment. If this is
necessary, the equipment should be observed to verify normal operation in the configuration in which it
will be used. However, even if used properly, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to other devices, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving device
• Increase the separation between the equipment
• Connect the equipment into an outlet on a circuit different from that to which the other device(s)
are connected
• Consult the manufacturer or field service technician for help
Use only ADC-approved cables and accessories with this device. Use of unauthorized cables or accessories
may result in increased emissions or decreased immunity. Portable and mobile RF communications
equipment can affect Medical Electrical Equipment.
Symbols
The following symbols are associated with the ADview:
SYMBOL DESCRIPTION
Manufactured by
ETL certified
Power supply contains materials which are
hazardous. Must be disposed of properly.
No SpO
2
alarm
Attention, consult accompanying documents.
Class II isolation equipment