American Diagnostic Corporation (ADC) ADview Modular Diagnostic Station - Manual (Page 34)

24
MEASURING TEMPERATURE WITH THE ADVIEW
Your ADview device can measure temperature with the optional temperature module. This module enables
you to take rapid, accurate temperature measurements ranging from 86°F-109.4°F. Typically, predictive
readings are obtained within ten to fifteen seconds, and direct readings within two minutes. The module is
equipped with the temperature probe for oral/axillary measurement, color-coded blue. A rectal probe that
is color-coded red is optionally available.
Temperature Units of Measurement
The device displays the temperature measurement in
:
• Celsius
• Fahrenheit
To choose a unit of measurement, depress the recessed button on the left side of the temperature module.
The icon for the selected unit is illuminated. This is now the default selection.
Temperature Measurement Modes
The device can measure temperature via three modes:
• Oral, indicated by on the display and measured using the blue probe
• Axillary, indicated by on the display and measured using the blue probe
• Rectal, indicated by on the display and measured using the red probe
All three modes can be used for both predictive and direct measurement. In the default predictive mode,
your ADview predicts temperature in 10-15 seconds with an accuracy of +/- 0.2 °F (+/- 0.1°C). When a
fever is detected, the measurement may last longer. In direct mode, the display continually updates until a
stable reading is reached. This mode is used in certain difficult conditions when a predictive reading is not
preferred or possible.
Axillary and rectal modes are preferred for children and compromised patients.
Using temperature probe and probe covers
In addition to the safety instructions for your ADview, here are some additional tips on using the probe and
probe covers for the optional temperature module:
• Use only ADC by SunTech supplied probe covers with this device.
• The device and probe covers are non-sterile. Do not use on abraded tissue.
• To limit cross contamination, use blue probes for taking oral and axillary temperature only. Use
red probes for rectal temperatures only.