Hangar 9 Beast 100cc ARF - Manual (Page 50)

50
 Step 3
Switch number two follows the same step
as switch number one. Before installing the
screws, use a 1/16-inch drill bit and slowly
drill pilot holes in the sheeting, then add a tiny
bit of thin CA to the screws before completing
the installation. If the steps are followed
properly as described, there is no need to
back the screws with a sheet of light plywood.
 Step 4
Follow the steps below to prepare the
receiver for mounting.
1. Apply masking tape to the bottom of the
receiver.
2. Glue using (CA) 1/4-inch foam to masking
tape.
3. Glue using CA (medium) Velcro (soft part)
to foam.