Hangar 9 Beast 100cc ARF - Manual (Page 39)

39
Required Parts
• Hangar 9 ball links, titanium rods and
bolts
• (4) JR 8711 or similar power digital servo
• (4) JR 1.5-inch single sided arm
• (2) 6- and 12-inch JR-HD extensions
Required Tools and Adhesives
• Threadlock • Drill
• Drill bit: 1/16-inch
• Ball driver: .050-inch, 3/32-inch
• Dental floss
• Masking tape
• Thin CA
• Hex wrench
• 30-inch rod
 Step 1
Assemble the linkage as in the pictures. Apply
threadlock to the nut and tighten until it bites
the wood but do not over-tighten.
The length of the titanium rod exposed
from the ball link to the control horn should
measure 22mm. Make sure to equally thread
the titanium rod in the ball link and the control
horn.
 Step 2
Attach a 6-inch extension for top wing or a
12-inch for the bottom wing. Use dental floss
to secure the connectors and tie two knots.
Wrap a round of masking tape over the knot
as an extra safety precaution.
Wing Servo and Control Horn Installation