Hangar 9 Beast 100cc ARF - Manual (Page 47)

47
Full down Elevator
Full Up Elevator
Battery Installation
Required Parts
• Battery Tray
• (2) Spekrum 2S, 2000mAh Li-Po
Required Tools and Adhesives
• 30-minute epoxy • Hobby knife
• Tie wraps
• Sticky-back Velcro (both sides)
• Masking tape
• Medium CA
Note: Do not glue your battery tray
in if the installed engine is not the
DA 100L, so the model can be
balanced by relocating batteries.
 Step 1
Prepare the tray completely before gluing it in
place.
Wrap masking tape to the bottom of each
battery. Then CA Velcro to the masking tape
on the batteries and also the tray. (i.e., soft
part of Velcro to the batteries and mating part
to the tray).