Hangar 9 Beast 100cc ARF - Manual (Page 24)

24
Required Parts
• Flying wire hardware package provided
with the kit
• Tail gear
Required Tools and Adhesives
• Crimper
• 1/4-inch wrench
• 3/32-inch ball driver
• Threadlock
 Step 1
The brass plates included in the hardware
will be used for this step. The brass plate has
two different size holes one small and one
big. The screw will pass through the larger
hole, while the smaller hole is for the wire.
Screw the brass plates to the vertical fin and
horizontal stab, as pictured. Do not tighten
down completely. If the holes are too tight
for the screw to pass through, drill the holes
carefully using a 1/8-inch drill bit. Do not put
excessive pressure on the stab while drilling.
Once the plate and screw are installed, rotate
the brass plate over the hinge line or edge of
the stab to be able to bend the side the wire
passes through or the clevis gets connected
to.
 Step 2
You will need to install the tail gear with
the two plates that have 3 holes. The tail
gear bolt goes through the center hole (use
threadlock).
Stab Flying Wire Installation