Hangar 9 Beast 100cc ARF - Manual (Page 13)

13
 Step 5
Go over the covering on the fuselage opening
with a heating iron. Glue the vertical fin to
the fuselage using either 30-minute epoxy or
wood glue. Wipe out the excess with alcohol
swabs. In case of using wood glue make sure
to allow 24 hours for wood glue to cure. The
advantage of using wood glue is that you can
easily clean the excess glue with water.
 Step 6
Bend the rudder hinge rod 90 degrees toward
the aft of the rudder and put clear tape on it.