beautypg.com

Hangar 9 Beast 100cc ARF User Manual

Page 34

background image

34

Step 2

Canister mounts come preglued but silicone

supports are not in place. Cut (8) 9/16-inch

pieces of silicone tube and mount them

through the slots in the mounts.

Step 3

Prepare the canisters and headers to slide in

the tunnel as follows.
1. Install the Teflon® coupler on the header.
2. Using a vice-grip slide both clamps on the

header.
3. Push the Teflon coupler on the canister

inlet and slide the clamp over it.
4. Push the Teflon coupler over the header

until there is 1/8- to 1/4-inch gap between the

header and canister. Since this might be a

little hard to do, use a heat gun and glove to

move the coupler over the header easier.
5. Slide the other clamp so it is in front of

the bump, towards the front of the plane. If

you install the clamp on the other side of the

bump, the canister will pull out in the air.
6. Install the canisters and use threadlock on

the bolts.