Hangar 9 Beast 100cc ARF - Manual (Page 49)

49
Required Parts
• (2) Spekrum 10-Amp Regulators
(SPMVR6010)
• AR9100 PowerSafe (SPMAR9100)
• (2) 24- and 36-inch JR HD Extension
Required Tools and Adhesives
• 1/8-inch lightweight plywood
• Medium and thin CA • Servo screws
• 1/16-inch drill bit
• Hobby knife
 Step 1
The regulators will be mounted under the
rudder tray toward the end of the pipe tunnel.
It is best to make 4 small footprints with light
plywood to mount each regulator on. Cut (8)
small pieces of light plywood. Use 1/16-inch
drill bit to mark the screw locations and apply
a drop of thin CA to the holes for strength.
Then glue the light plywood to the fuselage
balsa floor. Complete the installation by
screwing the regulators to the fuselage floor.
 Step 2
Switches will be installed at the side of
fuselage right behind the turtle deck. Mount
the cover of the switch over the fuse where
it needs to be installed and mark. Make sure
it looks straight and is in-line with the canopy
floor where the canopy sits. With a hobby
knife cut the balsa sheeting and complete the
installation following the pictures below.
Regulators and Receiver Installation