Hangar 9 Beast 100cc ARF User Manual
Page 18
18
Step 3
Reinsert the stab. Make measurements and
make sure it is where it should be.
With the plane sitting upright and without
moving it, use super thin (thin) CA to glue the
stab to the fuselage. Do not move anything,
thin CA will be absorbed. Glue little by little so
the covering won't be saturated with CA. Glue
on the left and right side of the stab and allow
time for the balsa to absorb the CA.
Next flip the plane to knife edge and repeat
the procedure all around the stab, top and
bottom.
Use a CA extension nozzle and apply some
CA from the elevator opening in the fuselage
over the stab and braces.
Watch for running CA. If you move the plane
before the CA is set, the CA will run onto the
covering. 30 minutes after this process, use
CA accelerator lightly and quickly. From 1 foot
away spray over the stab and fuselage.
.