Hangar 9 Beast 100cc ARF - Manual (Page 42)

42
 Step 6
To pass the bottom wing extension inside the
fuselage follow the directions below.
1. Make a size cut bigger than the plug in
the fuselage where the wing root is going in
and where it would line up with the extension
exit from the wing root. The cut can be as
big as 30x20mm so there is no problem with
catching the extension.
2. Plug the wing and mark it through the
fuselage slot.
3. Remove the marked balsa sheeting and
pull the plug.
Note: When plugging the wing,
pull the extension from inside
the fuse to avoid damaging the
extension by jamming it.