Hangar 9 Beast 100cc ARF - Manual (Page 43)

43
Note: The step below may not be
necessary with production models.
Please ignore if your model has the
anti-rotation pin sleeve preglued.
 Step 7
You will need to glue in the anti-rotation pin
sleeve for the bottom wing by following the
steps below.
1. Insert the sleeve and check the length.
If it is longer than it needs to be, make one
side flush with the side of the bottom fuse
and mark the other side to cut using a hobby
knife.
2. Insert the sleeve, making sure it is flush on
both sides and has thin CA over the edges.
The thin CA will soak in. Do not use CA
accelerator. Repeat the process two times
and allow time for it to dry. Do not build up
any bumps or hard points with CA.