Hangar 9 Beast 100cc ARF User Manual
Page 22
22
22
Required Parts
• Mid-wing section
• (8) 10mm, 4-40 screws
• (4) 6-32 screws
Required Tools and Adhesives
• 3/32 in and 7/64 in ball drivers
• Threadlock
Step 1
Insert the cabanes in the hatch slots such
that the tabs face away from fuselage. If there
is a need to slightly enlarge the slot, use a
hobby knife and remove balsa as necessary.
Apply a drop of threadlock to the screws and
bolt the cabane to the frame that has blind
nuts.
Note that there are slots to guide your ball
driver.
Step 2
Go over the mid-wing section with a heating
iron before installation. Install the mid-wing
section on the cabane. The mid-wing section
attaches to the cabane via (2) 6/32-inch
screws on each side. Use threadlock on the
screws.
Cabane and Mid-Wing Section Installation