Cub Cadet 2000 Series - Manual (Page 95)

Electronic Power Steering
89
6. Remove the EPS support bracket:
6a. Remove the two screws and washers that hold
the support bracket to the EPS using a 1/2”
wrench
6b. Remove the two nuts and bolts that secure the
bracket to the dash support using a pair of 1/2”
wrenches.
NOTE: A thin wrench, such as a tappet wrench can be slid
between the fender and the dash support to hold
the bolt heads. See Figure 6B.17.
7. Slide the support bracket out of the tractor.
8. Remove the two screws that hold the fuse box to the
dash support using a 3/8” wrench. See Figure 6B.18.
9. Open the two harness clamps that hold the main
harness to the dash support. See Figure 6B.19.
10. Unplug the EPS harness connector.
11. Unweave the harness from the dash support and let
it lay on the fender, pointing towards the seat.
Figure 6B.17
Tappet
wrench
Support bracket
Figure 6B.18
Screws
Figure 6B.19
Harness clamp
Cable clamp
EPS connector