Cub Cadet 2000 Series - Manual (Page 62)

2000 Series Tractors
56
18. Remove the fourteen screws securing the left trans-
mission housing to the right transmission housing
using a 1/2” wrench. See Figure 5.43.
19. Lift the left transmission housing off of the right
transmission housing. See Figure 5.44.
20. Lay the transmission down on the work surface.
21. Remove patch bolt and washer securing the right
hub assembly to the right axle using a 1/2” wrench.
22. Slide the hub off of the axle shaft.
23. Remove the 13T input pinion and ball bearing from
the right transmission housing using a wooden
dowel. See Figure 5.45.
NOTE: The 13T input pinion is pressed into the ball
bearing.
Figure 5.43
Left transmission
housing
Figure 5.44
Figure 5.45
pinion gear