Cub Cadet 2000 Series - Manual (Page 48)

2000 Series Tractors
42
Hydro neutral control adjustment
NOTE: Neutral control rarely goes out of adjustment on its own. If it needs adjustment, check for damaged
linkage or signs of tampering.
To perform the hydro neutral control adjustment:
1. Lift and safely support the rear of the tractor.
2. By-pass the seat safety switch. See Figure 5.6.
2a. Slide the seat to the full forward position.
2b. Flip the seat up.
2c. Press in the seat bottom until the tang on the
seat switch is fully extended.
2d. Place a spring clamp on the tang to hold the
seat switch in this position.
3. Disconnect the drive control rod from the hydro
pump by removing the bow tie clip. See Figure 5.7.
! CAUTION ! CAUTION
The tractor’s engine and drive system must be operated to complete this procedure. Confirm
that no hazards will be incurred by running the engine or operating the drive system.
• Work in a well vented area to prevent carbon monoxide poisoning or asphyxiation.
• Be careful to avoid contact with hot parts or moving parts.
Figure 5.6
Seat switch
Figure 5.7
Bow tie clip