Cub Cadet 2000 Series - Manual (Page 51)

Drive
45
5e. Disconnect the brake rod from the brake pedal
shaft by removing and discarding the cotter pin.
See Figure 5.14.
5f. Pull back on the brake rod and maneuver it past
the brake shaft and forward drive shafts.
5g. Unhook the brake rod from the brake spring.
6. Remove the drive control rod:
6a. Remove the bow tie clip that holds the drive
control rod and spring to the bell crank on the
pedal shaft. See Figure 5.15.
6b. Remove the bow tie clip that holds the drive
control rod to the hydro pump. See Figure 5.16.
6c. Slide the control rod off of the pin.
Figure 5.14
Cotter pin
Figure 5.15
Brake rod
Bow tie clip
Drive pedal shaft
Brake pedal shaft
Figure 5.16
Control rod
Bow tie clip