Cub Cadet 2000 Series - Manual (Page 94)

2000 Series Tractors
88
EPS removal/replacement
1. Open the hood.
2. Remove the battery: See Figure 6B.14.
2a. Disconnect the negative battery lead.
2b. Disconnect the positive battery lead.
2c. Remove the screw that secures the battery
hold down to the battery tray using a 3/8”
wrench.
2d. Swing the battery hold down out of the way.
2e. Remove the battery from the tractor.
3. Remove the dash by following the procedures
described in Chapter 4: Body.
4. Thread the screw from the steering wheel into the
steering shaft with a fender washer.
See Figure 6B.15.
NOTE: The screw and fender washer will keep the
steering shaft from falling out while lifting the
dash support off of the tractor.
5. Remove the three screws, indicated by the arrows
in Figure 6B.16, that secure the lower baffle to the
frame and dash support using a 3/8” wrench.
Figure 6B.14
Battery
Figure 6B.15
Fender washer
Figure 6B.16
Baffle