Cub Cadet 2000 Series - Manual (Page 19)

Engine Related Parts
13
Engine removal/installation
It may be necessary to remove the engine to perform
engine repairs such as replacing the ignition coil, flywheel,
alternator or to work on the cylinder heads.
To remove the engine:
1. Remove the hood by following the procedures
described in Chapter 4: Body.
2. Disconnect the negative battery cable from the bat-
tery.
3. Remove the muffler by following the procedures
described in the muffler section of this chapter.
4. Clamp off the fuel line just below the fuel pump.
See Figure 2.20.
5. Disconnect the ground cable from the left side of the
engine using a 1/2” wrench. See Figure 2.21.
6. Disconnect the PTO clutch harness.
7. Disconnect the engine harness.
8. Disconnect the starter wires. See Figure 2.22.
9. Remove the starter.
Figure 2.20
Fuel pump
Figure 2.21
Ground cable
Oil drain hose
Figure 2.22
Engine harness
Starter cable
Starter trigger wire