Cub Cadet 2000 Series - Manual (Page 52)

2000 Series Tractors
46
7. Remove the by-pass rod:
7a. Remove the bow tie clip. See Figure 5.17.
7b. Slide the by-pass rod out the rear of the trac-
tor.
8. Remove the rear wheels by removing the four lug
nuts that secure each wheel to the hubs using a 3/4”
wrench.
9. Remove the four bolts that attach the drive shaft to
the hydro pump using a 7/16” wrench.
See Figure 5.18.
10. Remove the four nuts and bolts (two on each side)
that hold the torque bracket to the frame using a
pair of 1/2” wrenches. See Figure 5.19.
Figure 5.17
By-pass rod
Figure 5.18
Drive shaft
Figure 5.19
Torque bracket nuts and bolts