Cub Cadet 2000 Series - Manual (Page 30)

2000 Series Tractors
24
8. Loosen the jam nut. See Figure 3.17.
9. Tighten or loosen the ferrule as needed so that it
aligns with the hole in the bell crank of the brake
pedal shaft with no slack in the brake spring.
10. Tighten the jam nut.
11. Attach the brake rod to the brake pedal shaft.
NOTE: The cotter pin that secures the brake rod to
the pedal shaft can be replaced with a bow
tie clip (714-04040).
12. Slide the brake pedal shaft to the right until it stops.
13. Install the E-ring and washer(s) on to the brake
pedal shaft.
NOTE: If the bushings popped out while shifting the
shafts, re-install them before installing the E-rings.
14. Slide the forward drive pedal shaft to the right until it stops.
15. Install the E-ring and washer(s) on to the drive pedal shaft.
16. Test drive the tractor in a safe area before returning it to service.
Figure 3.17
Jam nut
Ferrule