Cub Cadet 2000 Series - Manual (Page 57)

Drive
51
6. Remove the E-ring and washer from the reverse
pedal shaft. See Figure 5.28.
7. Slide the reverse pedal towards the right while sliding
the forward pedal shaft left far enough for the nut and
bolt of the roller to fit between the frame and the for-
ward pedal’s bell crank.
8. Rotate the reverse shaft until its bell crank and rollers
drop below the bell crank on the forward shaft.
See Figure 5.29.
9. Remove the hex bushings.
NOTE: The split hex bushing on the outboard side will be
difficult to pry off.
10. Slide the reverse shaft out of the frame.
11. Install the reverse pedal shaft by following the previ-
ous steps in reverse order.
NOTE: The split hex bush can be shorted to make it easier
to install.
12. Test drive the tractor in a safe area before returning it
to service.
Figure 5.28
E-ring
Figure 5.29
Reverse shaft bell crank
Forward shaft bell crank
´
´ ´
´
1(: 02',),('
Figure 5.30