Cub Cadet 2000 Series - Manual (Page 37)

Body
31
Fender and running board
On the Cub Cadet 2000 series tractor, the fender and the running board are two pieces. It may be necessary to
remove the fender and running board to gain access to items such as the deck lift shaft
When removing the fender and running board, it is generally easier to remove both of them as one piece.
NOTE: When working on the fuel tank, only the fender needs to be removed.
To remove/replace the fender:
1. Disconnect the seat switch. See Figure 4.15.
NOTE: On the GTX2154LE, it will be necessary to cut the
wire tie that holds the seat switch connector to the
seat frame.
NOTE: When reconnecting the seat switch plug on the
GTX2154LE, it must be wire tied back together
and attached to the seat frame. Failure to do this
can cause the connector to get caught in the seat
bracket and rip the wires out of the seat. If this
happens, the tractor will shut down when the brake
is released and the whole seat must be replaced.
2. Push the barbed fastener on the seat switch harness
out of the hole in the fender.
3. Remove the four socket headed cap screws that hold
the seat tracks to the fender using a T-40 torx driver.
See Figure 4.16.
Figure 4.15
Barbed fastener
Figure 4.16
Screws