Leica Geosystems Leica DISTO Pro - Manual (Page 42)

44 DISTO™ pro 4 / pro 4 a-1.0.0en English
en
Should all results be saved to data
memory?
Press and hold.
After saving, the menu function is
terminated and basic settings
displayed.
Should only a certain result be used?
Select desired result with
navigation keys.
Press briefly to confirm
selection.
Menu function is terminated and the
marked result displayed in basic
settings.
If desired save result to keypad or
data memory.
Calculation, contd.
Memory (6) Memory key 1 - 9 (6.1)
Nine memory places are allocated
with various in and output
possibilities to save intermediate
results or often used data
(addition,subtraction,pivot gap, etc.).
The menu function only serves to
save data. Calling up saved data is
done with the menu function "recall
key 1 - 9" (6.2).
Default setting: After reset all
memory keys (3.4) are deleted.
Precondition:
Before saving the respective
measured or computed value must
be displayed in basic setting.
Entries via keypad must be
confirmed with the Enter key.
Saving with menu
After calling up this menu function
the following is displayed:
space 5.7
1
2
3
4
0 26.369m 2
0 82.632m 2
0 20.684m
105.344m 3
, 5x
menu
1 measure settings
2 end cover
3 basic settings
4 basic functions
5 calculation
6 memory
memory 6
1 memory key 1-9
2 recall key 1-9
3 stack
4 data
The room length is displayed beside
the corresponding number "1".
At the same time the next width to be
measured is marked in black with the
corresponding number "2".
Measure width of the room as
described earlier and confirm with
Enter key.
Then measure room heigth (no. 3)
and confirm.
Press again briefly to start
computation.
The results of the computations are
explained with graphics and are
numbered in sequence (1-4):
1 ........................... ceiling / floor area
2 .................................... surface area
3 ................................. circumference
4 ............................................ volume
1
2
3
0 4.563m
0 4.563m
space 5.7
DISTO has many ways of saving
measurements and computations.
The last displayed measurement,
computation or entry is saved when
DISTO is switched off and appears in
the basic settings when DISTO is
switched on again.