Leica Geosystems Leica DISTO Pro - Manual (Page 19)

21 DISTO™ pro 4 / pro 4 a-1.0.0en English
en
The measurement reference symbol
in basic mode has a referencing line
and an arrow.
In Pointing mode the
measurement reference can
be changed with the (+/-) navigation
keys. The next measurement is
made from the changed reference
and after that from the preset
reference.
Front (1.1.1)
Measurement from the front
of the instrument (Measuring
optics).
Stand (1.1.2)
Measurement from the stand
connected to the rear of the
instrument.
This setting is also used when the
closing cap of the interface acts as
an auxiliary stop.
Rear (1.1.3)
Measurements from the rear
edge of the end cover.
The DISTO automatically adjusts the
reference to the attached end cover.
Read more in section "Using end
cover" and menu function "End cover
recognition on" (2.3.1).
After selecting and entering a
measurement reference, a short
confirmation appears and the menu
is terminated.
The DISTO changes to Normal mode
and displays the basic settings
Add / Subtract (1.2)
This adds or subtracts to / from
measurements. Tolerances can be
taken into consideration, e.g.
between unfinishing and finishing
dimensions.
offset 1.2
1 addition
2 subtraction
3 none
Measurement settings, contd.
PD-Z78
Default setting: None(1.2.3)
CAUTION:
After every input of or change
in Add / Subtract, carry out a control
measurement.
Save frequently used Add / Subtract
functions in the keypad memory and
call them up when needed.
Addition (1.2.1)
After calling up this menu function
the following is displayed.
Enter Add with keypad, recall
it from the keypad or stack
memory.
Press briefly to display the
units of Add.
Meters are automaticlly
added without having to
press the menu key.
Press briefly to confirm
entered addition.
Press briefly again to
terminate menu function.
A short confirmation is displayed.
DISTO switches to Normal
mode and displays in the
uppermost line of basic
setting the symbol of the
addition.
0.000m
addition 1.2.1
+