Leica Geosystems Leica DISTO Pro - Manual (Page 12)

14 DISTO™ pro 4 / pro 4 a-1.0.0en English
en
Any further language loaded via the
interface after the fourth one,
automatically replaces that fourth
loaded language.
Read instructions for the DISTO
Online Software on the CD-ROM
supplied.
Switching on Pointing mode
Briefly press.
DISTO changes from Nomal mode
into Pointing mode and the laser
lights up.
This symbol appears in the
basic settings display while
the laser is on.
If within 30 seconds no measurement
is triggered the laser turns off
automatically to save batteries.
DISTO is then back in Normal mode.
Press again to start laser and
to switch into Pointing mode.
English
1 Deutsch
2 English
3 Français
IMPORTANT:
• The proper way of inserting the
batteries is shown on the side of the
battery compartment.
• Always replace the entire set of
batteries. Never mix old and new
ones.
• Never use batteries made by diffe-
rent manufacturers or batteries of
different type.
4. Replace battery cover.
5. Place end cover in slot and push
in until it locks.
PD-Z09
Switching on DISTO
Press briefly.
DISTO is on and in nomal mode.
The display shows the basic settings
with the last mesured value.
Select desired language with
these keys.
A horizontal bar marks the selection.
A brief press confirms the
selection.
After a "Thank you" text, the basic
settings display appears.
Language selection can be changed
at any later time in menu "Language"
(3.2) .
It is possible to load an additional
fourth language via the DISTO
interface.
Switching on DISTO for the first
time
When following the described
procedure, the language selection
menu is displayed first.
3.504m
Insert / replace batteries, contd.
PD-Z10