Leica Geosystems Leica DISTO Pro - Manual (Page 21)

23 DISTO™ pro 4 / pro 4 a-1.0.0en English
en
After a brief press on the Enter key a
confirmation appears and the menu
is terminated.
The DISTO changes into Normal
mode and displays the symbol of the
time delay release in basic settings.
The delay can also be set in the
Pointing mode:
Keep pressed, until the
desired delay is reached.
The uppermost line displays the
symbol of the time delay release with
the delay below it.
Upon release the remainig seconds
to the measurement is displayed
(e.g. 59, 58, 57,...).
The last 5 seconds are counted
down with a beep sound. After the
last beep the measurement takes
place and the measured value is
displayed.
Measurement settings, contd.
Permanent (1.3.2)
After calling up this menu function,
the following is displayed:
The suggested delay is for all
following measurements and can be
changed as follows:
With the navigation keys.
Each key press increases,
respectively decreases delay
by 1 second.
With a keypad entry.
As long as this key is
pressed the delay increases
until the maximum of 60
seconds is reached.
After a brief press on the Enter key a
confirmation appears and the menu
function is terminated.
Here the operational mode of the
laser is set.
Normal mode: The laser switches off
automatically after 30 seconds.
Permanent mode: The laser remains
on in Pointing mode as long as the
DISTO is on.
The DISTO changes into Normal
mode and displays the symbol of the
time delay release in basic settings.
None (1.3.3)
After pressing the Enter key the
permanent delay is deleted and the
menu function terminated.
Laser (1.4)
Default setting: normal (1.4.1)
Normal mode (1.4.1)
After pressing the Enter key the
menu funtion is terminated and
basic settings are displayed.
This symbol appears in basic
settings as long as the laser
is on.
Permanent (1.4.2)
After pressing the Enter key the
menu is terminated and basic
settings are displayed.and the Per-
manent mode is started.
Every press on the On and
measurement key immediately
triggers a measurement.
This symbol is permanently
displayed in basic settings.
Only activate permanent
mode of laser if required as it
uses up battery power very rapidly.
10 sec
permanent 1.3.2
laser 1.4
1 normal mode
2 permanent