Leica Geosystems Leica DISTO Pro - Manual (Page 28)

30 DISTO™ pro 4 / pro 4 a-1.0.0en English
en
Point DISTO at target. Move
DISTO slowly and generously
over the target.
In tracking mode the DISTO
continuously takes single
measurements.
The shortest distance is continuously
updated and displayed.
Press again briefly to end
tracking.
DISTO changes to Normal mode and
displays the minimum tracking value
in basic settings.
Required distance (4.3)
Basic functions, contd.
Application examples:
• Saving the distances between
rafters and wooden beams in the
DISTO. As a result, the parts can be
exactly positioning on the
construction site using the DISTO.
• Saving distances of complete
developments of walls to the DISTO
and check on the site.
• Saving panel sizes in the DISTO
and recalling those values during
panelling.
These examples also show
how to facilitate procedures
of checking constructions.
PD-Z21
After calling up this menu function
- the laser lights up in Pointing mode,
- the following is displayed:
Application examples
• measuring clear room ceilings.
• minimum distance measurement in
case of rough and wavy surfaces.
• rectangular or horizontal measuring
without stand.
PD-Z43
--.---m
minimumtrac 4.2 required distance 4.3
1 constant
2 variable
Press briefly to start tracking.
In this submenu fixed or variable
distances for staking out can be
selected.
After a reset the entered distance
values remain unchanged.
In staking out a distance is divided
into segments.
The DISTO displays preset
distances, starting from a known,
aimed at point.
One-by-one these distances can be
checked, staked out or marked.