Leica Geosystems Leica DISTO Pro - Manual (Page 37)

39 DISTO™ pro 4 / pro 4 a-1.0.0en English
en
Calculation, contd.
At the same time the next height to
be measured is marked in black with
the corresponding number "2".
Measure height of triangle as
described and confirm with Enter
key.
Press and hold to start maximum
tracking. Press again briefly when
measurement is done.
Each of the displayed
measured values can be
selected with the navigation key
again and corrected by a new
measurement.
After confirming the last
measurement press briefly
again to start computation.
Press again to quit menu and
return to basic settings.
If desired save result to keypad or
data memory.
Trapezium HSH (5.3)
After measuring both heights and the
base side (HSH) of a trapezium, this
menu function computes
- the length and slope of the
trapezium sides,
- the area of the trapezium.
Applications:
• determine roof slope.
• determine gable area of a façade
with a shed roof.
The first height to be measured
(gutter height) and the corresponding
number "1" are marked in black.
Press briefly to change into
Pointing mode.
Point laser at the first point to be
measured.
Trigger measurement. Hold
DISTO steady.
If there is the possibility of a
shaky measurement in the
Pointing mode either:
- use the time delay release (x-key)
- or press the trigger key long enough
to start tracking.
The first measured value appears
beside the corresponding number
"1".
At the same time the base side of the
trapezium to be measured is marked
in black with the corresponding
number "2".
Measure the base side of the
trapezium as described earlier and
confirm with the Enter key.
Pressing and holding trigger key in
Pointing mode starts tracking.
The second measured value appears
beside the corresponding number
"2".
After calling up this menu function,
the following is displayed:
PD-Z66
1 0 3.439m 2
triangle SH 5.2
Press briefly to confirm
displayed value.
trapeze HSH 5.3
1
2
3
1
2
3
0 3.739m
0 3.739m
trapeze HSH 5.3