Leica Geosystems Leica DISTO Pro - Manual (Page 41)

43 DISTO™ pro 4 / pro 4 a-1.0.0en English
en
Calculation, contd.
Application:
• For volumes of trees, silos, etc.
• admeasurements in pipe systems.
After calling up this menu function
the following is displayed:
If desired, save result to keypad or
data memory.
Space (5.7)
This menu function computes from
lenght, width and height of a room
- floor and ceiling area,
- sum of the wall areas,
- circumference,
- room volume.
Application:
• Room dimensions are required by
craftsmen for painting, plastering,
carpeting, etc.
After calling up this menu function
the following is displayed:
space 5.7
1
2
3
1
circle 5.6
The diameter of the circle and the
corresponding number "1" are
marked in black.
Press briefly to change into
Pointing mode.
Position DISTO on the circumference
of the circle as reference.
Aim laser dot at a spot at the other
side of the circle (e.g. ground).
Trigger measurement. Hold
DISTO steady.
If there is the possibility of a
shaky measurement in the
Pointing mode either:
- use the time delay release (x-key)
- or press the trigger key long enough
to start maximum tracking.
Briefly press trigger key again as
soon as the measurement in
maximum tracking is done.
Press twice to confirm
measurement value and to
start computation.
Briefly press again to quit
menu and to display result in
basic settings.
1 0 0.250m 2
circle 5.6
For the first measurement the room
length and the corresponding
number "1" are marked in black.
Press briefly to change into
Pointing mode,
Align DISTO and aim with laser at
the first point to be measured.
Trigger measurement. Hold
DISTO steady.
If there is the possibility of a
shaky measurement in the
Pointing mode either:
- use the time delay release (x-key)
- or press the trigger key long enough
to start minimum tracking.
Briefly press trigger key again as
soon as the measurement in
minimum tracking is done.
Press briefly to confirm
displayed value.