Leica Geosystems Leica DISTO Pro - Manual (Page 39)

41 DISTO™ pro 4 / pro 4 a-1.0.0en English
en
Should all results be saved to the
data memory?
Press and hold.
After saving, the menu function is
terminated and basic settings
displayed.
Should only a certain result be used?
Select desired result with
navigation keys.
Press briefly to confirm
selection.
Calculation, contd.
Menu function is terminated and the
marked result displayed in basic
settings.
If desired save result to keypad or
data memory.
Gable area (5.5)
This menu function computes the
gable area of a façade with
symetrical pitch roof.
Application:
With the gable area the modified
room can be determined.
The first measured value appears
beside the corresponding number
"1". At the same time the base side
of the trapezium to be measured is
marked in black with the
corresponding number "2".
Measure base length of trapezium as
described earlier and confirm with
Enter key.
Press briefly again to start
computation after confirming
last measurement .
PD-Z68
After calling up the menu function,
the following is displayed:
If there is the possibility of a
shaky measurement in the
Pointing mode either:
- use the time delay release (x-key)
- or press the trigger key long enough
to start tracking.
Press briefly to confirm
displayed value.
The second measured value appears
beside the corresponding number "2"
At the same time the digonal to be
measured next is marked in black
with the corresponding number "3".
Measure diagonal of the trapezium
as described earlier and confirm with
Enter key.
Pressing and holding trigger key in
Pointing mode starts maximum
tracking.
Each of the displayed
measured values can be
selected with the navigation key
again and corrected by a new
measurement.
Pressing and holding trigger key in
Pointing mode starts tracking.
trapeze HSD 5.4
1
2
3
0 6.996m
39.8°
30.932m 2
1
2
3
0 3.516m
trapeze HSD 5.4
0 3.516m
trapeze HSD 5.4
1
2
3
0 3.516m
0 5.373m
0 5.373m