Leica Geosystems Leica DISTO Pro - Manual (Page 27)

29 DISTO™ pro 4 / pro 4 a-1.0.0en English
en
As with the room diagonal:
- aim DISTO first at a point near the
opposite corner,
- then move the beam slowly across
the corner.
In tracking mode, the DISTO
continuously takes single
measurements.
The furthest distance is continuously
updated and displayed.
Press again to end tracking.
DISTO changes to Normal mode and
displays the maximum tracking value
in basic settings.
Minimum tracking (4.2)
Minimum distance measurement is
done by using minimum tracking.
Basic functions (4)
, 3x
Maximum tracking (4.1)
Maximum distance measurement is
done by using maximum tracking.
PD-Z20
Application examples:
• measuring room diagonals.
• maximum measures on rough or
wavy grounds.
• maximum measures in large halls.
• roof- ridge heights from below the
façade.
• in general, where access is difficult
or under poor lighting conditions
(drainages, shafts, etc.)
After selecting this menu function
- the laser lights up in the Pointing
mode,
- the following is displayed.
Press briefly to start tracking.
DISTO changes into Normal mode
and displays the lit basic settings.
This symbol appears in the
upper most line of basic
settings.
Only use lighting when
required as it shortens
battery life.
Off (3.5.2)
Switches off display lighting.
After pressing the Enter key
- the menu function is terminated,
- a confirmation is displayed,
- basic settings are displayed.
Switch off (3.6)
This menu function switches the
DISTO off.
Pressing the Enter key is
acknowledged by a beep. Then the
DISTO switches off.
Under "Switching off DISTO"
further possibilities to switch
off the DISTO are described.
menu
1 measure settings
2 end cover
3 basic settings
4 basic functions
5 calculation
6 memory
basic settings 4
1 maximumtrac
2 minimumtrac
3 required distance
4 pythagoras
5 height
6 accuracy
--.---m
maximumtrac 4.1