Compex Technologies NetPassage 18A - Manual (Page 82)

73
L2TP
L2TP (Layer 2 Tunneling Protocol) is an extension to the PPP protocol
used for Virtual Private Networks (VPNs) that supports multiple protocols
and unregistered and privately administered IP addresses over the
Internet.
Follow these steps to setup L2TP
L2TP Configuration
Select
L2TP as your WAN Type at Select WAN
Type page.
At the WAN L2TP Setup page:
1. Select whether to enable DHCP.
2. Enter
Client IP Address .
3. Enter Network Mask .
4. Enter the Gateway .
5. Enter the Username of your Internet
account.
6. Enter the Password of your Internet
account.
7. Enter the IP address of your VPN Server .
8. Enter an Idle Timeout value between 30-
3600 seconds. Entering 0 will disable this
feature.
9. The Status section gives you a summary
of your connection settings such as:
•
IP address
• Network Mask
• Gateway IP Address
10. If you are online, clicking Disconnect will
disconnect your connection.
13. Click Apply .
14. Click Reboot button to restart the system
and allow the changes to take effect.
1
2