Compex Technologies NetPassage 18A - Manual (Page 81)

72
PPTP
The Point-to-Point Tunneling Protocol (PPTP) enables the
implementation of secure multi-protocol Virtual Private Networks (VPNs)
through public networks, enabling secure remote access at lower cost.
Follow these steps to setup PPTP.
PPTP Configuration
To use Email Notification,
please refer to Chapter 8:
Router Setup – Broadband
Internet Through the router –
WAN Setup Email Notification
Select
PPTP as your WAN Type at Select WAN
Type page.
At the PPTP WAN Setup page:
1. Select whether to enable DHCP.
2. Enter Client IP Address .
3. Enter Network Mask .
4. Enter the Gateway .
5. Enter the Username of your Internet
account.
6. Enter the Password of your Internet
account.
7. Enter the IP address of your VPN Server .
8. Enter
an Idle Timeout value between 30-
3600 seconds. Entering 0 will disable this
feature.
9. The Status section gives you a summary
of your connection settings such as:
•
IP address
• Network Mask
• Gateway IP Address
10. If you are online, clicking
Disconnect will
disconnect your connection.
11. Click Apply .
12. Click Reboot button to restart the system
and allow the changes to take effect.
1
2