Compaq 21264 - Manual (Page 157)

Alpha 21264/EV67 Hardware Reference Manual Internal Processor Registers 5–15
Ibox IPRs
5.2.14 PAL Base Register – PAL_BASE
The PAL base register (PAL_BASE) is a read-write register that contains the base phys-
ical address for PALcode. Its contents are cleared by chip reset but are not cleared after
waking up from sleep mode or from fault reset. Figure 5–21 shows the PAL base regis-
ter.
Figure 5–21 PAL Base Register
Table 5–10 describes the PAL base register fields.
5.2.15 Ibox Control Register – I_CTL
The Ibox control register (I_CTL) is a read-write register that controls various Ibox
functions. Its contents are cleared by chip reset. Figure 5–22 shows the Ibox control
register.
REG[4:0] [12:8] RO Destination register of load or operate instruction that triggered
the trap OR source register of store that triggered the trap. These
bits may contain the Rc field of an operate instruction or the Ra
field of a load or store instruction. The value is UNPREDICTABLE
if the trap was triggered by an ITB miss, interrupt, OPCDEC, or
other non load/st/operate.
INT [7] RO Set to indicate Ebox integer overflow trap, clear to indicate Fbox
trap condition.
IOV [6] RO Indicates Fbox convert-to-integer overflow or Ebox integer over-
flow trap.
INE [5] RO Indicates floating-point inexact error trap.
UNF [4] RO Indicates floating-point underflow trap.
FOV [3] RO Indicates floating-point overflow trap.
DZE [2] RO Indicates divide by zero trap.
INV [1] RO Indicates invalid operation trap.
SWC [0] RO Indicates software completion possible. This bit is set if the
instruction that triggered the trap contained the /S modifier.
Table 5–10 PAL Base Register Fields Description
Name Extent Type Description
Reserved [63:44] RO, 0 Reserved for Compaq.
PAL_BASE[43:15] [43:15] RW Base physical address for PALcode.
Reserved [14:0] RO, 0 Reserved for Compaq.
Table 5–9 Exception Summary Register Fields Description (Continued)
Name Extent Type Description
63 15 44 14 43 0
PAL_BASE[43:15] LK99-0027A