4 transferring data to another classpad unit, 4 transferring data to another classpad unit -4-1, Transferring data to another classpad unit – Casio ClassPad 300 PLUS User Manual
Page 709
20050501
16-4-1
Transferring Data to Another ClassPad Unit
16-4 Transferring Data to Another ClassPad Unit
This section details the steps you should perform in order to transfer data from one
ClassPad unit to another.
u ClassPad Operation
(1) Use the procedure under “Connecting to Another ClassPad Unit” on page 16-2-1 to
connect the two units.
(2) Use the procedure under “16-3 Configuring Communication Parameters” to configure
the parameters of the two units as shown below.
Cable Type: 3pin cable
Speed (3Pin): 115200 bps
Wakeup Enable: On
• If the speed settings of the two ClassPad units are different from each other, the
slower setting is used.
The remaining steps of this procedure are marked
Sender to indicate steps and
information that apply to the sending device, or
Receiver to indicate receiving device
steps and information.
Sender
(3) In the Communication application, tap [Link], and then [Transmit], or tap E.
• This displays the Select Data dialog box.
Sender
(4) Select the data you want to send.
• For more information, see “Selecting Data for Transfer” on page 16-4-3.
Sender
(5) Tap [OK].