Casio FX-CG10 - Manual (Page 444)

CASIO
13-13
Press
1(Yes) to replace the receiving calculator’s existing data with the new data, or 6(No)
to skip to next data item.
No: Overwrite check is not performed. If the receiving calculator already contains the same
type of data, the existing data is overwritten with the new data.
k Data Communication Precautions
Note the following precautions whenever you perform data communication.
• An error occurs whenever you try to send data to a receiving calculator that is not yet
standing by to receive data. When this happens, press
J to clear the error and try again,
after setting up the receiving calculator to receive data.
• An error occurs whenever the receiving calculator does not receive any data approximately
six minutes after it is set up to receive data. When this happens, press
J to clear the error.
• An error occurs during data communication if the cable becomes disconnected, if the
parameters of the two calculators do not match, or if any other communication problem
occurs. When this happens, press
J to clear the error, then correct the problem before
trying data communication again. If data communication is interrupted by the
J key
operation or an error, any data successfully received up to the interruption will be in the
memory of the receiving calculator.
• An error occurs if the receiving calculator memory becomes full during data communication.
When this happens, press
J to clear the error and delete unneeded data from the
receiving calculator to make room for the new data, and then try again.
k Exchanging Data with another Model Calculator
Though it is possible to exchange data between this calculator (fx-CG10/fx-CG20) and the
other CASIO calculator models listed under “To connect two calculators” (page 13-10), there
are certain restrictions that apply when exchanging data with an older model calculator.
u Transferring Data from this Calculator to an Older Calculator Model
Basically, only data for functions that are available on both this calculator (fx-CG10/fx-CG20)
and the older model can be transferred.
Data for a function that is available on this calculator but not on the older model cannot be
transferred. Transferring Graph mode graph expression data (Y=DATA) from this calculator to
the fx-9860G
II , for example, will cause color information to be dropped automatically, because
the fx-9860G II does not support color.