Casio FX-CG10 - Manual (Page 285)

CASIO
8-1
Chapter 8
Programming
Important!
Input in the Program mode is always performed using the Linear input/output mode.
1. Basic Programming Steps
Commands and calculations are executed sequentially.
1. From the Main Menu, enter the Program mode. When you do, a program list appears on the
display.
Selected program area
(use
f and c to move)
Files are listed in the alphabetic sequence of their names.
2. Register a file name.
3. Input the program.
4. Run the program.
• The values to the right of the program list indicate the number of bytes used by each
program.
• A file name can be up to eight characters long.
• The following are the characters you can use in a file name: A through Z, {, }, ’, ~, 0 through 9
• Registering a file name uses 32 bytes of memory.
Example To calculate the surface area (cm 2 ) and volume (cm 3 ) of three regular
octahedrons when the length of one side is 7, 10, and 15 cm,
respectively
Store the calculation formula under the file name OCTA.
The following are the formulas used for calculating surface area S and volume
V of a regular octahedron for which the length of one side A is known.
A A
S = 2
'
3 A 2 , V = A 3 ––––
'
2
3
S = 2
'
3 A 2 , V = A 3 ––––
'
2
3
8