Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.2 - Manual (Page 53)

Counterpart User Manual - Configuration 47
3.9 Display Menu
There are three display settings on the Counterpart .
Figure 3-15. DISPLAY Menu
Setting the display parameters from this top level menu is temporary - after a power cycle, the values will revert
to their previous values. Changes made to these parameters through the CONFIG menu are kept through a power
cycle.
3.10 ID Menu
The ID menu displays parameters for registers from 1 to 150. Sub-parameters are shown below.
Figure 3-16. ID Menu
DIO 1
DIO 2
DIO 3
DIO 4 STATUS Displays the status of each individual digital I/O port. If set as input, the display
shows input stats IN HI or IN LO. If set as output, pressing Enter toggles the
output between HI and LO. OUT HI or OUT LO.

OUT LO is active.
PORT1
PORT2 TEST Performs a loopback test on serial port 1 or 2. Connect jumper TX and RX
together on port 1 or port 2 before testing.
TEST Menu
Parameter Choices Description
Table 3-10. TEST Menu Parameters
ID Menu
Parameter Choices Description
Level 2 submenus
CONTRAST
XXXXXXX ID DISPLAY TEST SETUP AUDIT CALIBR
BRIGHT IMAGE
100
0-100%
50
0-100%
Negative
Positive
SETPTS
REG 1 REG 2
QUANTITY
SAME AS REG 1
CODE DESC PART NUM LOT UNIT WT TARE
VALUE VALUE VALUE LB
G
KG
OZ
OFF
UNITS LOCATION
XXXXXXX ID DISPLAY TEST SETUP AUDIT CALIBR
REG 150
SAME AS REG 1
VALUE VALUE VALUE VALUE VALUE
SETPTS