Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.2 User Manual
Page 32
26
Counterpart User Manual
Level 5 submenus - Format
PRIMRY
UNITS
DECPNT
DSPDIV
Allows you to set the primary units, decimal point format, and display divisions.
SEC
KG
G
LB
OZ
OFF
Allows you to set the secondary units.
Decimal point format and display divisions are selected automatically. Values are
kg=kilogram (default); g=gram; lb=pound; oz=ounce; and off.
If using the
the stream tokens must be changed to match in order to stream
secondary or tertiary.
TER
OFF
KG
G
LB
OZ
Allows you to set the tertiary units.
Decimal point format and display divisions are selected automatically. Values are off
(default); kg=kilogram; g=gram; lb=pound; oz=ounce.
If using the
the stream tokens must be changed to match in order to stream
secondary or tertiary.
Level 5 submenus - Calibration
WZERO
Allows you to view or change the zero calibration a/d count value.
WVAL
Allows you to view and edit the test weight value.
WSPAN
Allows you to view or change the span calibration a/d count value.
WLIN
POINT 1
POINT 2
POINT 3
POINT 4
POINT 5
Press ENTER to display and edit test weight and calibration values for up to five
linearization points. Perform linear calibration only after WZERO and WSPAN have been set.
Parameters include CAL1 - View or change linear point calibration value.
WGT1 - Sets test value.
REZERO
Removes offset from zero and span calibrations. Can be used during a span calibration
process using hooks and chains.
Level 6 submenus - Primary, Secondary, Tertiary
UNITS
LB
OZ
KG
G
OFF
Specifies primary units for displayed and printed weight. Values are lb=pound; oz=ounce;
kg=kilogram; g=gram.
DECPNT
8888800
8888880
8888888
8.888888
88.88888
888.8888
8888.888
88888.88
888888.8
Allows you to place the decimal point position. Use the ID (
) and TARGET (
) keys to
place the decimal point where desired.
DSPDIV
1D
2D
5D
Display divisions. Selects the minimum division size for the primary unit’s displayed weight.
SETUP Menu
Parameter
Choices
Description
Table 3-3. Setup Menu Parameters (Continued)
Note
Note