Rice Lake CB-2 Concrete Batch Controller Version 2.0 - Manual (Page 74)

70 Installation/Operation Manual
Parameter Name Duplicate Value The specified parameter value must be unique and the entered value was already in use.
Error Detected - Check Printer For
Report The data diagnostic utility detected errors in the database.
Error! Can’t Find Order #n The specified order number (n) was not found in the orders database.
Error! Loads Database Full The maximum number of loads record (1000) has been reached - no more loads may be
scheduled until some records are deleted. Please press 25623 and press enter to clear
the loads data base. When Confirm clear loads data base is displayed, press Yes.
EStop Pressed, No Discharge The discharge softkey was pressed while the EStop button was in its down position.
EStop Pressed, No Restart The Restart softkey was pressed while the EStop button was in its down position.
EStop Pressed, No Start The Start softkey was pressed while the EStop button was in its down position.
Find Order Failed The order record to be deleted was not found in the orders database.
Parameter Name Format is Invalid The entered data is not in the correct format for the specified parameter.
Greater Than Plant Capacity The size of the requested load is greater than the defined plant capacity. Increase plant
capacity in the batching limits section of the Admin menu.
Invalid Action This is a system error that should not normally occur. Contact your service representative.
Invalid Date Either the system date or the delivery date entered for an order was invalid.
Invalid Field Selection This is a system error that should normally not occur. Contact your service representative.
Invalid Material Type The material type was not either weighed or metered. Most likely indicates a corrupt
materials database.
Invalid Order Quantity The entered order quantity was either greater than 10000 or less than or equal to 0.
Invalid Password The password entered when trying to enter CB-2 setup mode was incorrect.
Invalid Port (1-4 only) The CB-2 only supports serial ports 1 thorugh 4.
Invalid Range of Mix IDs The ending mix ID number for a request for a mix design report for a range of mixes was
less than the initial ID.
Invalid Scale Weight One of the scales is reporting an error state.
Invalid Slump The valid range for the slump is 1 to 14 (or 2 to 36 in metic systems)
Invalid Time Either the system time or the delivery time entered for an order was invalid.
Invalid Value The new password value is not in integer
Parameter Name is Invalid Invalid keyword.
SBB is Not a Digital Input The entered slot and bit is not a valid digital input port address.
SBB is Not a Digital Output The entered slot and bit is not a valid digital output port address.
Jog Record Not in Database A weighed material had no matching record in the jogs database. this probably indicates
a corrupt jogs or material database.
Late Discharge An admixture missed its add point. This might occur, for instance, if an admixture was to
be added with the weigh up of a specific material and that material was not incuded in the
current mix design.
Less Than Already Supplied An attmept is being made to adjust the required amount for an order to less than what
has already been delivered.
Load ID Not in Database This is a system error that should not normally occur. contact your service representative.
Load Index Out of Range This is a system error that should not normally occur. Contact your service representative.
Load Too Big For Plant The size of the requested load is greater than the defined plant capacity.
Load Too Small to Batch The size of the requested load is less than the minimum batch size for the plant.
Loads Database Error An error occured while trying to add a load record to the loads database.
Parameter Name Longer Than NN The string type parameter was longer than the specified maximum
Problem Description
Table 10-2. Error Codes