Rice Lake CB-2 Concrete Batch Controller Version 2.0 - Manual (Page 51)

Installation/Operation Manual - Utilities 47
6.1.1 Usage Reports
Usage reports can be run daily weekly, monthly or yearly. Press the appropriate softkey to select which usage
report to run.
05/30/2013 08:13AM
More ->
Entry Mode Cancelled
SCALE 1
Material Name Unit Day Week Month Year Inv
Trash Sand
Sand
#8 Limestone
#57 Gravel
#57 Limestone
Pea Gravel
Cement
Cement 2
Water
Material Usage/On-hand
Usage
Reports
Clear
Day Totals
(1) Tons
(2) Tons
(3) Tons
(4) Tons
(5) Tons
(6) Tons
(10) Tons
(11) Tons
(41) Tons
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00 0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00 0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00
0.00 0
0
0
0
0
0
0
0
0 0
0
0
0
0
0
0
0
0
Use NAV keys to select material
Adjust
Inventory
Clear Week
Totals
Figure 6-6. Usage Reports Parameters
Printing a Usage Report
Use the following steps to print a usage report but do not adjust inventory during this procedure.
1. Press the
Utilities
softkey (shown in Figure 6-5 on page 46).
2. Press the
Material Usage
softkey (also shown in Figure 6-5).
3. Press the
Usage Report
softkey.
4. Press the softkey that corresponds with the report that you would like to print ie: daily, weekly monthly.
5. Wait until the
Check Printer for Report
message is displayed on the screen.
6. Press the
More
softkey to get back to the
Back to Usage Menu
softkey.
7. Press the
Back to Usage Menu
softkey.
8. Press the
More
softkey to get
Back to Utilities
menu.
9. Press the
Back to Utilities
softkey.
10. Press the
Back to Main Menu
softkey to fully exit the parameter.
6.1.2 Adjust Inventory
Use the following steps to adjust inventory but do not print reports while doing this procedure.
1. Press the
Utilities
softkey (shown in Figure 6-5 on page 46).
2. Press the
Material Usage
softkey (also shown in Figure 6-5).
3. Use the
Up
or
Down
arrows to select the product you wish to adjust.
4. Press the
Inventory Adjust
softkey.
5. Use the numeric keys on the 920i to enter your amount of product that you wish to add to inventory and
then press
Enter
to save that amount.
6. When done, select the
More
softkey to get
Back to the Utilities
softkey.
7. Press the
Back to the Utilities
softkey and press
Back to Main Menu
softkey to fully exit the parameter.
6.1.3 Clear Day Totals through Yearly Totals
Press the
Clear Day Totals, Clear Week Totals
, etc. to clear off the
Material Usage/On Hand
screen. The values shown
on the 920i will clear off to zero.