Oldcastle BuildingEnvelope Reliance-IG SS - Manual (Page 29)

26 



R E L I A N C E - I G S S I N S T A L L A T I O N M A N U A L
Glazing Notes:
1) Interior Gaskets: GP-113 Wedge Gasket
Exterior Gaskets: GP-123 Push-In Gasket
2) Remove gaskets from reels and allow to relax overnight before installing.
3) Cut gaskets 1/4" longer per foot of aluminum extrusion to allow for relaxation.
4.7 Install vertical face covers, then horizontal face covers leaving equal gap at the ends. Make sure
weep hole is on bottom. To prevent damaging snap-on face caps during installation, hold a short
piece of 2 x4 wood block over the cap and strike with a Stanley 3 lbs Compo-cast dead blow soft face
hammer. Strike cap at clip locations. Do not hit the face cap directly with a mallet. See Details "A".
FIGURE 28
Glazed Assembly
GP-123 Gaskets
See notes below
for installation
GP-113 Wedge Gasket
See notes below
for installation
Wood 2"X4"
block
Detail A
GLAZING INSTRUCTIONS