Kontron CG2200 Carrier Grade Server - Manual (Page 3)

www.kontron.com
www.kontron.com
Kontron CG2200 Carrier Grade Server Installation and Maintenance Guide
2.11 Embedded USB Flash Drive ................................................................................................... 13
2.12 Server Board (Baseboard) ...................................................................................................... 13
2.13 Riser Card Assembly .............................................................................................................. 14
2.14 Ethernet NIC Ports ................................................................................................................. 15
2.15 Remote Management Module 4 .............................................................................................. 15
2.16 Power Supply Subsystem ....................................................................................................... 15
2.17 System Cooling ...................................................................................................................... 15
2.18 Processors and Memory DIMMs ............................................................................................. 16
2.18.1 Processors ......................................................................................................... 17
2.18.2 Memory ............................................................................................................. 17
3 Standard Component Installations and Upgrades .......................... 18
3.1 Before You Begin ................................................................................................................... 18
3.1.1 Tools and Supplies Needed ..................................................................................... 18
3.1.2 System References ................................................................................................. 18
3.2 General Installation Procedures .............................................................................................. 18
3.2.1 Removing the Chassis Cover ................................................................................... 18
3.2.2 Re-installing the Chassis Cover ............................................................................... 19
3.2.3 Removing the Front Bezel ....................................................................................... 20
3.2.4 Re-Installing the Front Bezel .................................................................................... 20
3.2.5 Removing a Riser Card Assembly ........................................................................... 20
3.2.6 Re-Installing a Riser Card Assembly ........................................................................ 21
3.2.7 Removing the Processor Air Duct ............................................................................ 22
3.2.8 Re-Installing the Processor Air Duct ........................................................................ 23
3.3 Internal System Components Configuration and Installation Procedures ................................. 23
3.3.1 Configuring Memory DIMMs .................................................................................... 23
3.3.2 Supported Memory .................................................................................................. 24
3.3.3 Publishing System Memory ..................................................................................... 25
3.3.4 Integrated Memory Controller Operating Modes. ...................................................... 25
3.3.5 Memory RAS ........................................................................................................... 25
3.3.6 Installing Memory DIMMs ........................................................................................ 26
3.3.7 Replacing or Removing Memory DIMMs .................................................................. 27
3.3.8 Adding or Replacing a Processor ............................................................................. 28
3.3.9 Inserting the Heat Sink ............................................................................................ 32
3.3.10 Configuring Jumpers on the Server Board .......................................................... 33
4 Optional Component Installation Procedures ................................. 36