Initial setup and requirements, Chapter 1 – Dynojet 248x: Installation Guide User Manual
Page 5

Document #98219101 1 - 1
Chapter 1
Initial Setup
and Requirements
Thank you for purchasing the Dynojet
Dynamometer. This document will give you the
information you need to install the Dynojet
Dynamometer (four post model). If you have any
questions please call Dynojet at (800) 992-4993.
Introduction
Before installing your Dynojet Dynamometer,
there are a few factors to consider. This
chapter, “Initial Setup and Requirements”, is
a brief overview of what you need to know to
install your dynamometer and an overview of
the installation steps.
Comprehensive
instructions are included in the remaining
chapters. “Initial Setup and Requirements”
should help you to decide where you want to
place your dynamometer in your shop, where
to place the Dynojet electronics, what you
need to unload your dyno and what you will
have to provide for the dynamometer.