Dynojet 248x: Installation Guide - Manual (Page 22)

3 - 4 Document #98219101
dyno gets the 7/16” bolt, lock washer, and flat
washer. The 3/8” bolt, lock washer and flat
washer go into the anchor in the floor.
Step 8
Raise the lift and put the roller assembly
portion of the interface kit on the cross beam
of lift at its center line. Refer to the Interface
Assembly Drawing in Appendix A. Position
the roller wheel part of the interface on the lift
so it passes through the tube part of the
interface on the dynamometer.