Dynojet 248x: Installation Guide - Manual (Page 15)

Document #98 219101 2 - 3
Dynamometer Input/Output Module:
The dynamometer I/O module sends and receives
data from the dynamometer and the hand held
pendant. The module also contains a buzzer and
light which are activated when either the vehicle
or dynamometer speed limit is approached.
The green LED glows when the dynamometer
input/output module is receiving power.
The amber LED flashes proportionally to
dynamometer drum RPM.
This 25-pin receptacle connects to the shielded
cable from the dynamometer.
This 9-pin receptacle connects to the hand held
pendant which houses the button used to
Start/Stop acquiring data. The pendant may also
contain a brake switch.