Dynojet 248x: Installation Guide User Manual
Page 26

3 - 8
Document #98219101
Basic Kit:
A: DynoWare EX+ Modules
B: Air Brake Pressure Regulator
C: Air Brake Control Valve (Replaced by N
with Proportional Air brake systems)
D: DynoWare EX+ Power Supply and Cord
E: Wall Mount for DynoWare EX+
F: DynoWare Cable
G: Dynamometer Control Pendant
H: Serial Port Cable
I: Primary Inductive Cable
J1&2: Secondary Inductive Cables
K: Mounting Hardware
L: Pickup Card
Optional Proportional Air Brake Systems:
(M) Booster Valve Assembly (Replaces C)
(N) Electronic Pressure Regulator (EPR)
(O) DIN Rail (for mounting the EPR)
(P) Temperature Sensor
(Q) Temperature Sensor Bracket
(R) Four 1/4" Button Head Allen Bolts
In addition to the parts listed above there is an
EPR cable.
Note:
This section is laid out to aid the operator with
the installation of Standard Air or Proportional
Air braking systems. Steps with“Standard Air“
in front of them are to be followed solely by
operators that are installing the Standard Air
Brake system. Steps with“Proportional Air“ in
front of them are to be followed solely by
operators that are installing the Proportional Air
Brake
system.
Steps
without
any
designation are to be followed by both.